- Home
- All products
- Red Engine Start + Cigarette Lighter Eject Button Trim For BMW 1 2 3 4
Red Engine Start + Cigarette Lighter Eject Button Trim For BMW 1 2 3 4 5 Series
Type: Vehicle Specific Product
Vendor: Xotic Tech
Description:
This listing features on 1 set of Premium quality ABS Engine Start Button + Alloy Aluminum Eject Button Cigarette Lighter cover trim specially for BMW Vehicles below.
Fitment:
Fits for BMW F/G Chassis Series with "A OFF" Button
-
For 1 Series F20 F21 2012-2019
For 2 Series F22 F23 F45 F46 2015-2019
For 3 Series GT F30 F31 F34 F35 2012-2019
For 4 Series F32 F33 2014-2019
For 5 Series F10 F11 G30 G38 2011-2020
For 5 Series GT 2010-2016 F07
For 6 Series F12 F13 2012-2018
For 6 Series GT G32 2018+
For 7 Series F01 F02 G12 2009-2018
For X1 F48 F49 2016+
For X2 F39 2019+
For X3 F25 G01 G08 2011-2019
For X4 F26 F02 2015-2019
For X5 F15 G05 2014-2019
For X6 F16 2015-2018016 (not suitable for 2016+)X6 Series F16 2015 2016 (not suitable for 2016+)
- Please check your button in order to fit before purchase
Please ensure the part of your car like our picture shows
Freatures:
- Condition: 100% Brand New
-
The Package include one piece of Premium quality ABS Engine button cover + one piece of Aluminum Alloy Eject Button Cigarette Lighter cover - Upgrade the look of the interior of your car
- Waterproof and never fade, wear-resisting & scratch-resistant
- Protect the installed area from scratches and dirty
- Easy installation, simply peel and stick on
- Surface must be clean and dry prior to adhering
Installation:
- Please clean the place where you want to installed it, use rubbing alcohol first. (make sure to remove the dirty,like grease, wax or dust)
- To check the installation area according to the vehicle with this product first and then release the back of tape paper (double-sided tape, a label) is removed
- Products are equipped on the vehicle with exactly and use a clean cloth to press evenly is attached.In the case of a relatively low temperature, heat installation location, and plate with a hair dryer on low setting
- Put the product in desired location carefully and press down for about 1-2 minutes, The adhesive should be cured after 12-hours
- Products within 24 hours after installed, please avoid washing your car and touching the water