- All products
- Glossy Red Aluminum Alloy Engine Start Button Cover Trim For Ford F-15
Glossy Red Aluminum Alloy Engine Start Button Cover Trim For Ford F-150 2016-21
Type: Vehicle Specific Product
Vendor: Xotic Tech
This listing features on one set of High quality Glossy Red Aluminum Alloy key Engine Start Stop Button Cover Trim for Ford F-150 2016-2021.
- 【Applicable Models】- Compatible with Ford F150 2016-up original car, please confirm that this product is suitable for your car before buying.
- 【Premium Materials】 - Made of premium quality aluminum alloy materials, wear-resistant, scratch-proof, dust-proof, and upgraded protection, not only protection but also give you a luxury look.
- 【Customized Design】 - This product is customized for your car, and can be highly compatible with your car interior. The increase in color makes the interior more beautiful, and also greatly improves the quality of the car.
- 【Easy to Use and Remove】- The cover is very easy to install, no other tools are needed, and there is adhesive on the back, so installation is simple and quick. And will not damage the original accessories or affect the use of buttons.
- For Ford F-150 2016-2021
- Please ensure the part of your car like our picture shows
- Condition: 100% Brand New
- Color: Glossy Red
- Material: Premium quality Aluminum Alloy
- Upgrade the look of the interior of your car
- Waterproof and never fade, wear-resisting & scratch-resistant
- Protect the installed area from scratches and dirty
- Strict Factory QC test ,High Quality guaranteed. Durable and color will not fade out
- Easy installation, simply peel and stick on
- Surface must be clean and dry prior to adhering
- Please clean the place where you want to installed it, use rubbing alcohol first. (make sure to remove the dirty,like grease, wax or dust)
- To check the installation area according to the vehicle with this product first and then release the back of tape paper (double-sided tape, a label) is removed
- Products are equipped on the vehicle with exactly and use a clean cloth to press evenly is attached.In the case of a relatively low temperature, heat installation location, and plate with a hair dryer on low setting
- Put the product in desired location carefully and press down for about 1-2 minutes, The adhesive should be cured after 12-hours
- Products within 24 hours after installed, please avoid washing your car and touching the water.
- Compatible of vehicles are only for reference, cause the same car model may be differently produced in different country. Please ensure the part of your car like our picture shows, or it will not fit, if any differences, please contact with us before purchase, thanks!
- Due to light and angle of view, there may be slight color difference.
- If you have any problems, please leave us a message and we will help you.
Other fine products