- Home
- Best Selling Products
- Red Center Console Control Switch Button Knob Ring Trim For Ford Musta
Red Center Console Control Switch Button Knob Ring Trim For Ford Mustang 2015-up
Type: Vehicle Specific Product
Vendor: Xotic Tech
Description:
This listing is for 1 set of Red color Interior Control Button Cover For Ford Mustang 2015-up.
These control knob cover are made with high quality material which will give a beautiful color and shape for you. They will give you a new elegant and stand out look in a minute. It's perfect for your dear Ford.
Perfect for interior decoration, improve the interior appearance of your Vehicles, shown as pictured,giving your car a unique look and prevent your car from scratch and dirt.
Non-destructive Installation. Just press the cover into switch knobs directly. It will not damage the original accessories or affect the use of the knob.It allso equips with adhesive tape to prevent falling off.
Fitment
- For Ford Mustang 2015-up
- Please make sure your control button is the same as the picture we show before purchase.
Placement On Vehicle
- Engine Start Stop Button
- Dashboard Control Button
- Radio Volume Control Knob
- Headlight Switch Control Knob
Features
- 1 set of Aluminum Alloy Radio Volume/Tune control knob + Headlight Switch Button Control rings
- Color: Red
- Volume Control Ring Diameter: 1.88''
- Headlight Switch Ring Diameter: 1.96''
- 100% Brand new and high quality
- Material: made with premium quality Aluminum Alloy ; High quality ABS Material
- Surface must be clean and dry prior to adhering
- It will give your car brand new elegant and luxury look
- No modification needed
- Just press the cover into switch knobs directly
Installation Guide
- Please clean the place where you want to install it, use rubbing alcohol first. (make sure to remove the dirty, like grease, wax or dust)
- To check the installation area according to the vehicle with this product first and then release the back of tape paper (double-sided tape, a label) is removed
- Products are equipped on the vehicle with exactly and use a clean cloth to press evenly is attached. In the case of a relatively low temperature, heat installation location, and plate with a hair dryer on low setting
- Put the product in desired location carefully and press down for about 1-2 minutes, The adhesive should be cured after 12-hours
- Products within 24 hours after installed, please avoid washing your car and touching the water./ Don't move the item or wash your vehicle within 24 hours after installation
Note
- Compatible of vehicles are only for reference, cause the same car model may be differently produced in different country. Please ensure the part of your car like our picture shows, or it will not fit, if any differences, please contact with us before purchase, thanks!